too hot? too cold?
too hot? too cold?
This is layer 2 or 3. It will be covered by the next few layers but I feel like it shouldn't be this fugly. I'm using Cura's Standard Quality except for temp which is set to 205. The filament is Inland PLA.
You're viewing a single thread.
18 comments
-
Does that top surface feel ridged? To me this looks more like an issue with either overextrusion or z offset too low than temperature.
-
I second z offset. Weird that this happens only at a certain regular "column". Could be hiding an underextruded strand on the level below. In that case your temp might not be stable.
-
18 comments