Repetitive banding issue
Repetitive banding issue
Hey all, so this is the biggest thing I've tried to print. I'm using PETG. I'm getting a lot of repetitive bands of underextrusion that seem to stack up and get worse as the print progresses.
What do you think is causing this? Is this just an inherent thing in the way an Ender 3 works by moving the bed?
1
comments
I recently had an issue that caused similar issues. Ended up being a bad wheel on the Z axis. Wheel was damaged and the carriage would move up and down as the Z axis traversed causing that stripped pattern.
Good luck!
1