Skip Navigation
Jump
Ender 3 Pro motherboard recommendations
  • I can personally really recommend the fly e3 pro v3. It’s well priced and is a 32 bit board that comes with both an stm32 and a esp32 built in allowing you to run duet reprap firmware without a spare raspberry pi thanks to an amazing port. Since it’s reprap firmware you get all the advantages of klipper like web gui, input shaper, editing config files without recompiling etc but without having a spare and quite expensive raspberry just lying around. https://s.click.aliexpress.com/e/_DCEqwdT

    https://teamgloomy.github.io/fly_e3_pro_v3_general.html

    1
  • Jump
    Got klipper up and running on the new Ender-3 V3 se
  • You should try to install octoprint on a raspberry pi. It's the easiest way to get a web gui if you don't want to mess with the firmware or mainboard

    5
  • Jump
    Are you replacing Reddit with Lenny?
  • I have tried to but am currently using both although I only use reddit on my computer at home. Sadly I find that the content just isn't here. Sure there's a lot of tech and gaming stuff but if you aren't interested in that then there isn't all that much else

    5
  • Jump
    Poddrekomendationer
  • Ifall du vill ha lite mer av en dokumentär podd så kan jag verkligen tipsa om "13 Minutes to the Moon" av BBC som handlar om apollo i säsong 1 och apollo 13 i säsong 2. Bland de bästa jag lyssnat på.

    Sen kan jag även rekommendera "Hamish & Andy" en komedipodd av två, extremt populära förre detta australienska radiopratare.

    1
  • Jump
    Final Austrian GP Results after 9 Post-Race Penalties
  • This is ridiculous. They should really try to automate the detection process of when a car is going over the line so that penaltys can be handed out swiftly

    1