RG35xx-H should be good to go, ultimate protection!

Got my rg35xx-h and the provided screen protector had no glue, so I ordered one off Amazon, this is what came. I think I'll just stick to my 3d printed case.

EDIT: Edit just checked these didn’t have glue either, what’s going on haha Brand is Mr Sheild

6 comments

Looks like it's running an amlogic chip. The only experience I have with linux and amlogic is the radxa zero. I've got a few with armbian and one with openelec. They are solid. I wonder if this gets a mainline kernel or not? I like the design.

3
- I'll try and remember to dig about when I setup the SSH and let you know
  
  2
- Not by a long shot, it's on 4.9.170 about 2019 that's a bit worrying :D
  
  2
Is it perhaps static cling, or do you have to apply with a water/soap solution?

2
- Thought the same even though it's not in the instructions used a bit of isopropyl nothing
  
  1
I usually just cut these down to the correct size I want with a ruler and a utility knife.

1

You've viewed 6 comments.