Skip Navigation
InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)AT
Posts
1
Comments
31
Joined
2 yr. ago
  • It might be an issue with concentricity. If the nozzle is not perfectly centered it creates a step that the filament can snag on. It can then cause the already softened filament to bunch up during deretraction forming a plug in the heat break. I had this issue with cheap nozzles. Everything starts fine and after a few layers it all stops for apparently no reason. Cranking up the heat makes it better for a bit, before making it worse

  • Generally I would agree, and give them the benefit of the doubt, but it smells too fishy. A lot of goodwill was pumped up during testflight, but went dead very soon after money got involved, almost a full 180 and with barely a word afterwards. For all intents and purposes they still took the money and ran

  • Thanks! I’m in Belgium, so location recommandations are welcome, too. The 70x100 frames I found so far are frightfully expensive. It feels ord to spend more on the frame than the art it contains. That said, I would spend the money rather than doing the print the disservice of housing it in a cheap looking frame

  • Bean @lemmy.world
    atest123 @lemmy.world

    Randomly freezing up

    For the past few days the app has been randomly freezing up and crashing after some time up to minutes, but more often requiring a force quit. No real trend. Happens both while scrolling the feed, scrolling comments or opening links without a clear trigger. iPhone 11 on ios 16.6