Running into inconsistent extrusion when printing a circular model
Running into inconsistent extrusion when printing a circular model
I have been trying for many hours now to print this circular model, but have been running into inconsistent extrusion and stringing. just before printing this, I successfully printed a set of Hextraction tiles, so I'm not really sure what the issue is. I also printed this model successfully in the past with the same settings.
I am using a Sovol SV06 with stock firmware, and PLA with the hotend at 195° C.
I also did a full calibration to see if that would fix the issue, and it did not.
185C is cold for PLA. It may work for slow prints, but my personal minimum has always been around 200C and my normal print temperature is usually at 215C.
Long extrusions are probably sucking out all the heat from the nozzle and it's temporarily jamming until the filament can heat up again.
Think of the hotend as a reservoir for heat. For long extrusions, it will drain really fast. Once the hotend isn't printing for a quick second, it will fill back up really fast. At 185C, you are trying to print without a heat reservoir. I mean, it'll work, but not during intense or extended extrusions.
16Yep, I run my pla at 206-209 with great results. .35 first layer at 200% .3 after
Tevo tornado
3That was a typo, sorry, it was set at 195 C
1All good! It's the same situation as I described and I see that increasing temps did help. It's good to do a temperature tower test for quality and also a full speed test after that. After temperature calibration, print a square that is only 2 or 3 bottom layers that covers the entire bed at full speed or faster. (It's essentially a combined adhesion/leveling/extrusion volume/z offset test, but you need to understand what you are looking at to see the issues separately.)
If you have extrusion problems, the layer line will start strong from the corners, get thin during the acceleration and may thicken up again at the bottom of the deceleration curve. A tiny bit of line width variation is normal, but full line separation needs attention.
Just be aware if you get caught in a loop of needing to keep bumping up temperatures as that starts to get into thermistor, heating element or even some mechanical issues/problems.
2
It looks like underextrusion at speed. It might be a clog or you might want to try a higher hotend temperature. PLA can have inconsistent ideal temperatures even with the same brand due to different colors and additives between batches and 185 is on the low side.
7That was a typo it was actually 195, but still thanks this worked!
2
If nothing's changed since you last print, including the filament, I would suspect a jam/clog. Is the extruder clicking?
3