Wi-Fi 7 to get the final seal of approval early next year, new standard is up to 4.8 times faster than Wi-Fi 6::There are a lot of 'draft' Wi-Fi 7 devices around, but 'Wi-Fi 7 Certified' devices will only come to market sometime next year.
Well all they need is a router that supports that standard and devices that support that standard. However, I don't know if the devices have that standard yet, but, when they do, it should be useable.
I just upgraded to a WiFi 6E router. Both my phone and my laptop support 6E.
Speeds are great, until you leave the living room (where the router is). Go up to my bedroom, and 6E won't even connect. So it's fast, but 6Hz has trouble going through walls.
Most of the other devices in the house are on 5GHz and that's still super fast and able to reach basically everywhere.
the difference between 5Ghz (5150-5895) and 6Ghz (5925-7125) is not really sufficient to blame for most home uses. It's expected as a rule to lose about 10-20% more power than 5Ghz through walls (where 5Ghz lost 100% more power than 2.4 Ghz does). It's much more likely that your new WAP just does less power or worse antenna than the old one did.
I am just glad that 6E and 7 have access to 6GHz so that once my devices support it i can disable both 2.4 and 5GHz to lower interference from neighboring networks. The higher it goes in frequency the less interference everyone will get.
Less RF interference, sure, but a lot more wall and physical object interference as the higher frequencies aren't able to go through them nearly as well.
Overall, it's great to have more spectrum available, especially in a less crowded range. More options means more optimal solutions to be had.
Thats true. And the higher it goes the more money you have to spend to properly network. I have heard 60GHz requires you to be in the same room as the AP but gives fantastic speeds. What i eventually plan on doing is buying say a 24 port PoE switch and running 2 cables to the ceiling in each room (for redundancy) and putting an AP in every room. I know that will cost a good chunk of money, but with an AP in every room that would future proof the network for higher and higher frequencies in the future.
It's a good excuse to use your old router on a separate network for those devices. If you have a smart enough switch, you can even keep them completely off your LAN, which can be good for security. YMMV though, and if you need direct access it won't work that way.
You wont want to disable 2.4 and 5GHz on wifi 7. The reason it gets so much higher speeds than 6e is that it can send data on all 3 spectrum simultaneously. If you turn off 2.4 and 5GHz you would essentially be limiting yourself to 1/2 speed.
"Wi-Fi 7 supports superior connectivity for emerging use cases with high levels of interactivity and immersion,"
How far can I be from the access point and how many walls can there be in between? WiFi at home is already pretty bad just two rooms over from the router.
me over hear with my gigabit-ethernet plugs in every wall as if they were as important as electricity... upgrade those suckers to 10-gig-ethernet, and wifi-has nothing over other than mobility... mobility until you leave the room.. sounds about like being on a wire.
wireless needs a better understanding, and for most that have no understanding they just see faster as better, when no wireless is better than a wired connect, that is why the cellar towers, fiber connection, and even coax-connections all are needed to "power the wireless".
i'm shocked at how many new or remodeled homes have no "ethernet port" but yet they will have power plugs-n-mass every where in the house, electricity for everything, and then they plugin 5Ghz repeaters into all the wall sockets so that they get decent room to room speeds.
That's the most frustrating thing. I have 3 mesh waps in my house, but if you connect in a different room you get 2.4ghz. At this point I need a mesh wap in every room.
As the wavelengths get shorter, so too does my patience :/
I’ll wait as I put in WiFi 6E last year. I get 500-800mbps. I positioned 3 units through out. My laptops support WiFi 6 and 6E. So…no reason to upgrade since they cannot hit the higher speeds without direct line or adapter.
Even Wifi 6E devices are way too expensive still, especially considering how poor 6GHz range is without a mesh system. I just upgraded to a new router since my old one would bottleneck my internet connection on wired, not because I needed faster wifi speeds.
In theory, this should be like having wireless Thunderbolt. Hopefully cameras are quick to adopt this. This would be super handy for sending 8K video to a workstation.
Speed is higher on 5GHz and 6GHz because the channels are wider. For every 10MHz of channel width you can get ~100mbps if there is no interference. 2.4GHz goes so far that it is pretty much impossible to get a channel with no interference and speeds suffer for it. 5GHz has much more bandwidth and lower range so you are much more likely to find a free channel to use unless you live in an apartment building or such. 6GHz has even larger bandwidth available and goes even less distance than 5GHz, though not much less, so finding a free channel should be even easier.
Lower frequency have longer distance coverage, higher frequency have better speeds but shorter distance coverage, and here is common wavelengths of WiFi 2.4GHz 5GHz 6GHz, also new WiFi stands adds new features like mi-mo was added in WiFi 5 and something something raycasting WiFi was added in WiFi 6 and i honestly don't know what been added in WiFi 7 but specs gonna be better for sure
If the cause of the poor 2.4ghz range was tons of interference on that band, then maybe. But lower frequencies simply go farther, so 6ghz will always have a lot shorter range than 2.4ghz. Though while it's impossible to change the laws of physics, it might be possible to change the laws around wireless telecommunication to allow it to transmit at a much higher power - not sure if WiFi 7 does.